Recent content by smoky

  1. S

    Selective Exhaust Options for 2023 Silverado ZR2??

    Are there any options for a "selective" exhaust for my 2023 the same or similar as the Dual Mode Active Exhaust that comes on the new model ZR2's? I love the active/sport sound of a Borla S type or AWE, etc, but would like something more "low key" at certain times such as hunting, church...
  2. S

    DSSV Values

    I have the take off DSSV's sitting tucked away in my shed. May decide to part with them. They were taken off at about 4,500 miles when I did my custom build with a 6" in lift. Also have the factory lift parts. What is anyone seeing these sell for?
  3. S

    Powered Running Boards

    I have the amp xtreme steps on mine and they have performed perfectly. The finish did start to peel a little and I had the custom shop I use spray them with bed liner and now they look better than when brand new. Very good traction on them with the bed liner. The custom shop has since started...
  4. S

    ZR2 Randomly going into "limp" mode

    That would be a "hard" pill to swallow, but I'd consider it if it would "straighten" it out!!
  5. S

    ZR2 Randomly going into "limp" mode

    Yes, transmission was serviced at 45,000 miles.
  6. S

    ZR2 Randomly going into "limp" mode

    Thanks! Any chance my pedal commander could be causing issues? It's been on the truck since about 5,000 miles (now at 62,000) and has never seemed to cause an issue, but I've read some other threads on here that made me at least question it.
  7. S

    ZR2 Randomly going into "limp" mode

    On 3 separate occasions, my 2023 1500 6.2L ZR2 has made a "shudder", as if driving over a rumble strip or railroad tracks and immediately goes into decreased acceleration mode. It throws a check engine light and flashes "service transmission" and "service traction control". On the first two...
  8. S

    Condensation In Headlight

    Dealership said the extended warranty does not cover water in the headlights.
  9. S

    Condensation In Headlight

    Has anyone dealt with the issue of condensation in this headlight. I'm hopingthinking that a vent is blocked and causing the issue but can't find any information specific to this headlight on how to fix. Recently, the entire turn signal has gone out, so I will need to fix or replace soon. Any...
  10. S

    My Current Build - BDS 4 inch lift - Ridge Grappler 37s

    Those are bushwacker OE flares that were cut to fit and plastiwelded back together and color match painted. The custom shop did them when they did the rest of the truck.
  11. S

    My Current Build - BDS 4 inch lift - Ridge Grappler 37s

    Very nice! I have the identical wheels and tires on my ZR2 with the exception that my tires are 35's. I do not care for the amount of "fender gap" created. Looking seriously into 37's and debating on a wheel change to accommodate for an overall lighter total wheel and tire weight per corner...
  12. S

    37's and axle ratio

    Hello all. I currently have 35" ridge grapplers on 20x10 -18 fuel wheels on my 2023 ZR2 Silverado. It's lifted a total of 5" and can adjust to 6-6.5 according to my custom shop. I'm interested in changing my tire aspect ratio and I am debating between 37" tires on my current wheels or...
  13. S

    Black Betty Just About Complete!

    Really not too bad, around $1,500. That includes purchasing the flares, all labor to make and install along with custom painting from a nearby auto paint shop.
  14. S

    Black Betty Just About Complete!

    The fender flares are custom made by the shop I used. They are standard bushwacker flares that were cut and plastiwelded to the specs of the OE flare, then colormatched to the truck.
  15. S

    Black Betty Just About Complete!

    Badges are blacked out. Some were replaced and some were colormatch painted with Chevrolet touch up paint.
Back
Top