Active Cruise Control not working.

[mfbearded]

woke up today and noticed an orange icon on the dash (cant stand that). little research along with some other messages indicated an issue with the active cruise control and also seemed to include the lane departure system. Ive already learned its a sensitive system so i checked the camera. no issue there. I then found a post on a forum describing the same issue, the advise was to pull the F11 fuse from the passenger side fuse panel with e vehicle off, wait a minute, insert the fuse back in and start the car. All should be fixed. I am happy to report that the issue seems to be corrected. Im assuming its some electronic hiccup that pulling the fuse forced a reset or code clear. hope this helps with anyone having the same issue.

 

[MNNJR69]

I had the same type of issues about 6 months ago. I had 3 bad camera modules on mine and they caused the same issues. No adaptive cruise, no lane departure, no blind spot indicator and no auto high beams. All of those systems are dependent on the modules working properly.

FYI if you have to have modules replaced, they will have to reprogram the computer and it will not work if you have the Range DFM/AS module connected. Just make sure to take it off before you take it for service or they will try to say you have a bad ECM.
I left mine on when I took it to the dealer because I didn't think it would cause an issue. My SA at the dealer knows I have it and usually says something if I need to disconnect it before service. When the camera modules went on mine they replaced them and tried to reprogram the ECM three times before they finally called me and said I had a bad ECM. I ran up to the dealership and took the range module off and the programming went through within a couple of minutes.