2024 cold air intake

[ICE_ZR2]

is anyone installed cold air intake for 2024?
I need to know is any change for oem exhaust sound especially with sport mode

 

[AXE]

Yes, do it!

 

[ICE_ZR2]

Yes, do it!

Thanks AXE
I really try to search for any videos 2024 with air intake I couldn't find it,
Do you know which one is better k&n or AFE ?

 

[securityguy]

is anyone installed cold air intake for 2024?
I need to know is any change for oem exhaust sound especially with sport mode

Save your money...total waste.

 

[ZR2xBIZON]

@securityguy there he is!

 

[AXE]

Thanks AXE
I really try to search for any videos 2024 with air intake I couldn't find it,
Do you know which one is better k&n or AFE ?

I like AEM or AFE and they have better dry flow filters for longevity and easy maintenance. I dont have one on my ZR2, but there are some guys running them. I run a Magnaflow exhaust on mine and I like the way it sounds and didn't think the extra intake noise would matter to me.

You might pick up a couple HP, but it won't be that noticeable on a 425 HP motor. Have not seen any before and after dyno work on the intakes, so don't expect any huge gains.

 

[NullNomad]

Save your money...total waste.

Wait you said it was only a waste if I added the amsoil stickers with the cai.

 

[ICE_ZR2]

I like AEM or AFE and they have better dry flow filters for longevity and easy maintenance. I dont have one on my ZR2, but there are some guys running them. I run a Magnaflow exhaust on mine and I like the way it sounds and didn't think the extra intake noise would matter to me.

You might pick up a couple HP, but it won't be that noticeable on a 425 HP motor. Have not seen any before and after dyno work on the intakes, so don't expect any huge gains.

Im not looking for intake noise im looking for little bit extra noise from oem exhaust when I make it in sport mode that my Purpose,

 

[ICE_ZR2]

Save your money...total waste.

I think you are right if you talking about 2023 and previous because it’s silent,
But what im asking about 2024 because it’s different oem exhaust.

 

[mksz51]

It will do NOTHING to amplify exhaust noise - if anything it could be an overall "negative" due to a new distracting sound from under the hood. Factory air intakes are typically quite good anymore and gains from aftermarket without other modifications are minimal to nonexistent.

 

[AXE]

Im not looking for intake noise im looking for little bit extra noise from oem exhaust when I make it in sport mode that my Purpose,

It's not that expensive to try. Anytime you do a larger intake, you'll get more sound from under the hood.

 

[Koppster]

At least two things I like about the K&N:

1. Open box (direct access to airflow)

2. Less air filter replacements (cost savings)

 

[securityguy]

At least two things I like about the K&N:

1. Open box (direct access to airflow)

2. Less air filter replacements (cost savings)

The OEM box is just fine. I would install the Airaid Jr. kit with a dry free flow filter and call it a day. Leaves sensor in the stock position and there is zero wrong with the airbox. If anyone goes K&N, do NOT get an oiled filter...they are terrible and cause problems.

 

[Koppster]

@insecureguy,

Thank you for your opinions, I am pretty darn happy with my K&N.

 

[securityguy]

@insecureguy,

Thank you for your opinions, I am pretty darn happy with my K&N.

Hopefully you did a dry filter versus a wet filter.

 

[AXE]

Hopefully you did a dry filter versus a wet filter.

The primary issue people have with oiled filters is over oiling. The excess oil is pulled in to the intake tract and gums up the mass air flow sensor and throttle body. This throws codes and causes performance issues.

I have been running an AEM on my previous Duramax for 11 years now. My boynis still driving it and that synthetic filter still looks and performs great. I cleaned it every 5000 miles. Always had plenty of dust trapped in it. Don't blow it out, rinse it out from the clean side. Then hit it with warm water and mild soap.

 

[Koppster]

The primary issue people have with oiled filters is over oiling. The excess oil is pulled in to the intake tract and gums up the mass air flow sensor and throttle body. This throws codes and causes performance issues.

I have been running an AEM on my previous Duramax for 11 years now. My boynis still driving it and that synthetic filter still looks and performs great. I cleaned it every 5000 miles. Always had plenty of dust trapped in it. Don't blow it out, rinse it out from the clean side. Then hit it with warm water and mild soap.

Good data Axe, that’s what folks need to hear. My K&N came pre-oiled and the maintenance recommendation is 100K. Had the same setup on my LTZ, no issues.

Thanks
Rick

 

[securityguy]

The primary issue people have with oiled filters is over oiling. The excess oil is pulled in to the intake tract and gums up the mass air flow sensor and throttle body. This throws codes and causes performance issues.

I have been running an AEM on my previous Duramax for 11 years now. My boynis still driving it and that synthetic filter still looks and performs great. I cleaned it every 5000 miles. Always had plenty of dust trapped in it. Don't blow it out, rinse it out from the clean side. Then hit it with warm water and mild soap.

It still lets more "stuff" thru than a dry filter and not worth the risk IMPO. I use oiled filters when I was much younger and haven't now for over 25 years. Just my 2 cents and everyone will do as they will which is fine with me...not my truck.